Home / Services / Flooring Installation

Flooring

Flooring Installation in St. George, UT

Tile, luxury vinyl plank and laminate installed on a flat, prepared subfloor. If you are thinking about changing your floors, here is how the process works and what drives the price.

Start your projectGet a free price range
Utah B100 licensedBuilding since 2019SUHBA memberHablamos español
New floor installed by Golden Maya Inc. in a St. George home

Floors we install

Porcelain and ceramic tile

Large format tile, wood look tile and patterns, set flat with the right thinset and leveling system.

Luxury vinyl plank (LVP)

Waterproof, quiet and a good fit for busy homes and rentals.

Laminate

A budget friendly wood look for bedrooms and living areas.

Shower and bathroom floors

Sloped shower pans and bathroom tile with waterproofing.

Old floor removal

We remove carpet, tile or old plank and haul it away.

Subfloor prep

Grinding, patching and leveling so the new floor stays flat and does not crack.

How to change a floor, step by step

  1. Pick the material for the room

    Tile or LVP for kitchens, baths and entries. LVP or laminate for bedrooms. In St. George heat and dust, tile and LVP are the easiest to keep clean.

  2. Measure the square footage

    Length times width for each room, plus 10 percent extra for cuts and pattern waste.

  3. Remove the old floor

    Carpet, pad and tack strip come out. Old tile is chipped off and the slab is cleaned.

  4. Prepare the subfloor

    This is the step most people skip. High spots are ground down and low spots are filled, so planks do not flex and tile does not crack.

  5. Install and finish

    The floor goes in, then baseboards, transitions and quarter round are installed and the room is cleaned.

How it works

Free visit

We measure every room and check the slab or subfloor.

Material and quote

You choose the floor. We price removal, prep and install on separate lines.

Install

Most homes are done in a few days per area.

Walkthrough

We check transitions, baseboards and cleanup with you.

How much does it cost to replace a floor?

Flooring is priced per square foot. The total depends on the material, how much old floor has to come out and how much leveling the subfloor needs. Open our free budget calculator, choose flooring, enter your square footage and you will see a price range in seconds.

Free price range

Choose the project, enter the size and see a range in seconds. No email needed.

Open the calculator

Why homeowners choose Golden Maya

We finish what we startA written scope, a schedule and payments tied to finished work. No disappearing halfway.
You always know what is happeningA weekly update with photos, and one person to call.
Licensed and insuredUtah B100 General Building Contractor #11595237-5501. Member of the Southern Utah Home Builders Association.
Local and bilingualBased in St. George. We work with you in English or Spanish.

Flooring Installation questions

Is LVP or tile better for St. George homes?

Both work well. Tile lasts longer and handles heat and water best. LVP is warmer underfoot, quieter and costs less to install.

Can you install new flooring over old tile?

Sometimes LVP can go over flat, solid tile, but in most cases we remove it so the new floor sits at the right height and stays flat.

How long does flooring installation take?

A typical 1,000 square foot area takes about 2 to 5 days, depending on removal and subfloor prep.

Do you move furniture?

We can move standard furniture. Let us know about pianos, safes or large electronics before the job.

Related services

Kitchen Remodeling Bathroom Remodeling Home Remodeling All servicesSee our work

Flooring Installation for homeowners in St. George, Washington, Hurricane, Ivins and Kayenta, Santa Clara, La Verkin, Toquerville, Leeds, Springdale, Apple Valley, New Harmony, Enterprise, Veyo, Central, Pine Valley and Cedar City.

Not sure where to start?

Tell us about the project. We visit, listen and give you an honest plan and price.

Start your projectCall (435) 216-2739